/*
 *  Definitions for IO devices.  Used only in C.
 */
typedef struct Uartregs Uartregs;
Uartregs *uart3regs;

/*
 *  IRQ's defined by SA1100
 */
enum
{
	IRQgpio0=	0,
	IRQgpio1=	1,
	IRQgpio2=	2,
	IRQgpio3=	3,
	IRQgpio4=	4,
	IRQgpio5=	5,
	IRQgpio6=	6,
	IRQgpio7=	7,
	IRQgpio8=	8,
	IRQgpio9=	9,
	IRQgpio10=	10,
	IRQgpiohi=	11,
	IRQlcd=		12,
	IRQudc=		13,
	IRQuart1b=	15,
	IRQuart2=	16,
	IRQuart3=	17,
	IRQmcp=		18,
	IRQssp=		19,
	IRQdma0=	20,
	IRQdma1=	21,
	IRQdma2=	22,
	IRQdma3=	23,
	IRQdma4=	24,
	IRQdma5=	25,
	IRQtimer0=	26,
	IRQtimer1=	27,
	IRQtimer2=	28,
	IRQtimer3=	29,
	IRQsecond=	30,
	IRQrtc=		31,
};

/*
 *  GPIO lines (signal names from compaq document).  _i indicates input
 *  and _o output.
 */
enum
{
	GPIO_PWR_ON_i=		1<<0,	/* power button */
	GPIO_UP_IRQ_i=		1<<1,	/* microcontroller interrupts */
	GPIO_LDD8_o=		1<<2,	/* LCD data 8-15 */
	GPIO_LDD9_o=		1<<3,
	GPIO_LDD10_o=		1<<4,
	GPIO_LDD11_o=		1<<5,
	GPIO_LDD12_o=		1<<6,
	GPIO_LDD13_o=		1<<7,
	GPIO_LDD14_o=		1<<8,
	GPIO_LDD15_o=		1<<9,
	GPIO_CARD_IND1_i=	1<<10,	/* card inserted in PCMCIA socket 1 */
	GPIO_CARD_IRQ1_i=	1<<11,	/* PCMCIA socket 1 interrupt */
	GPIO_CLK_SET0_o=	1<<12,	/* clock selects for audio codec */
	GPIO_CLK_SET1_o=	1<<13,
	GPIO_L3_SDA_io=		1<<14,	/* UDA1341 interface */
	GPIO_L3_MODE_o=		1<<15,
	GPIO_L3_SCLK_o=		1<<16,
	GPIO_CARD_IND0_i=	1<<17,	/* card inserted in PCMCIA socket 0 */
	GPIO_KEY_ACT_i=		1<<18,	/* hot key from cradle */
	GPIO_SYS_CLK_i=		1<<19,	/* clock from codec */
	GPIO_BAT_FAULT_i=	1<<20,	/* battery fault */
	GPIO_CARD_IRQ0_i=	1<<21,	/* PCMCIA socket 0 interrupt */
	GPIO_LOCK_i=		1<<22,	/* expansion pack lock/unlock */
	GPIO_COM_DCD_i=		1<<23,	/* DCD from UART3 */
	GPIO_OPT_IRQ_i=		1<<24,	/* expansion pack IRQ */
	GPIO_COM_CTS_i=		1<<25,	/* CTS from UART3 */
	GPIO_COM_RTS_o=		1<<26,	/* RTS to UART3 */
	GPIO_OPT_IND_i=		1<<27,	/* expansion pack inserted */
};

enum
{
	/* hardware counter frequency */
	ClockFreq=	3686400,
	Stagesize=	1024,
	Nuart = 4,

	/* soft flow control chars */
	CTLS= 023,
	CTLQ= 021,
};

typedef struct PhysUart PhysUart;
typedef struct Uart Uart;

/* link twixt hardware and software */
struct PhysUart
{
	void	(*enable)(Uart*, int);
	void	(*disable)(Uart*);
	void	(*kick)(Uart*);
	void	(*intr)(Ureg*, void*);
	void	(*dobreak)(Uart*, int);
	void	(*baud)(Uart*, int);
	void	(*bits)(Uart*, int);
	void	(*stop)(Uart*, int);
	void	(*parity)(Uart*, int);
	void	(*modemctl)(Uart*, int);
	void	(*rts)(Uart*, int);
	void	(*dtr)(Uart*, int);
	long	(*status)(Uart*, void*, long, long);
};

/* software representation */
struct Uart
{
	QLock;
	int	type;
	int	dev;
	int	opens;
	void	*regs;
	PhysUart	*phys;

	int	enabled;
	Uart	*elist;			/* next enabled interface */
	char	name[NAMELEN];

	uchar	sticky[4];		/* sticky write register values */
	ulong	freq;			/* clock frequency */
	uchar	mask;			/* bits/char */
	int	baud;			/* baud rate */

	int	parity;			/* parity errors */
	int	frame;			/* framing errors */
	int	overrun;		/* rcvr overruns */

	/* buffers */
	int	(*putc)(Queue*, int);
	Queue	*iq;
	Queue	*oq;

	uchar	istage[Stagesize];
	uchar	*iw;
	uchar	*ir;
	uchar	*ie;

	Lock	tlock;			/* transmit */
	uchar	ostage[Stagesize];
	uchar	*op;
	uchar	*oe;

	int	modem;			/* hardware flow control on */
	int	xonoff;			/* software flow control on */
	int	blocked;
	int	cts, dsr, dcd, dcdts;		/* keep track of modem status */ 
	int	ctsbackoff;
	int	hup_dsr, hup_dcd;	/* send hangup upstream? */
	int	dohup;

	int	kinuse;		/* device in use by kernel */

	Rendez	r;
};

/* general purpose I/O lines control registers */
typedef struct GPIOregs GPIOregs;
struct GPIOregs
{
	ulong	level;		/* 1 == high */
	ulong	direction;	/* 1 == output */
	ulong	set;		/* a 1 sets the bit, 0 leaves it alone */
	ulong	clear;		/* a 1 clears the bit, 0 leaves it alone */
	ulong	rising;		/* rising edge detect enable */
	ulong	falling;	/* falling edge detect enable */
	ulong	edgestatus;	/* writing a 1 bit clears */
	ulong	altfunc;	/* turn on alternate function for any set bits */
};

extern GPIOregs *gpioregs;

/* extra general purpose I/O bits, output only */
enum
{
	EGPIO_prog_flash=	1<<0,
	EGPIO_pcmcia_reset=	1<<1,
	EGPIO_exppack_reset=	1<<2,
	EGPIO_codec_reset=	1<<3,
	EGPIO_exp_nvram_power=	1<<4,
	EGPIO_exp_full_power=	1<<5,
	EGPIO_lcd_3v=		1<<6,
	EGPIO_rs232_power=	1<<7,
	EGPIO_lcd_ic_power=	1<<8,
	EGPIO_ir_power=		1<<9,
	EGPIO_audio_power=	1<<10,
	EGPIO_audio_ic_power=	1<<11,
	EGPIO_audio_mute=	1<<12,
	EGPIO_fir=		1<<13,	/* not set is sir */
	EGPIO_lcd_5v=		1<<14,
	EGPIO_lcd_9v=		1<<15,
};
extern ulong *egpioreg;

/* Peripheral pin controller registers */
typedef struct PPCregs PPCregs;
struct PPCregs {
	ulong	direction;
	ulong	state;
	ulong	assignment;
	ulong	sleepdir;
	ulong	flags;
};
extern PPCregs *ppcregs;

/* Synchronous Serial Port controller registers */
typedef struct SSPregs SSPregs;
struct SSPregs {
	ulong	control0;
	ulong	control1;
	ulong	dummy0;
	ulong	data;
	ulong	dummy1;
	ulong	status;
};
extern SSPregs *sspregs;